Vendor Name: Network Appliance
Exam code: NS0-502
Exam Name: NetApp Certified Implementation Engineer – SAN
Click the link below to get full version
http://www.certifyguide.com/exam/NS0-502/
Question: 1.
|
Click
the Exhibit button.
<exhibit name=NS0-502-1>
</exhibit>
You see the following error on the storage controller's
console or messages file.
What is the most likely cause for this error?
A. portal group misconfiguration
B. iSCSI CHAP misconfiguration
C. iSNS misconfiguration
D. IPsec misconfiguration
Answer: B
|
Question: 2
|
.
What would you use to share a data LUN among multiple
servers where each server has simultaneous write access?
A. host-based BootBIOS
B. host-based multipathing
C. host-based volume manager
D. host-based clustered file system
Answer: D
|
Question: 3
|
.
Click the Exhibit button.
<exhibit name=NS0-502-3>
</exhibit>
In the diagram shown, a portset is created on controller
1 with the command: controller1>portset create -f ntapportset 0b. This
portset is bound to the igroup with all the initiators in it.
How many paths can host 1 see to a LUN on controller 1?
A. six paths
B. four paths
C. eight paths
D. two paths
Answer: D
|
Question: 4
|
.
What are three relevant perfstat counters to check for
unaligned I/O that do not fall on the WAFL boundary? (Choose three.)
A. wp.partial_write
B. vvol_read.io_valid
C. read/write_align_histo.XX
D. read/write_partial_blocks.XX
E. xinode content misses
Answer: ACD
|
Question: 5
|
.
Click the Exhibit Button
<exhibit name=NS0-502-5>
</exhibit>
The table highlights the space management policy that is
defined for a particular flexvol, acmevol.
Based on the information provided in the table, which
action will the storage controller take when it runs out of space in the
volume?
A. It will try deleting Snapshot copies first to reclaim
space before trying to grow the volume.
B. It will grow the volume before deleting Snapshot
copies.
C. It will only try deleting Snapshot copies to reclaim
space and will not grow the volume.
D. It is irrelevant since fractional_reserve is 0%.
Answer: C
|
Question: 6
|
.
Which utility on Windows 2003 and Windows 2008 can be
used to collect information about firmware and driver versions for an Emulex
LP1xxxx/LPe1xxx HBA?
A. EMutil
B. SANutil
C. fcp config
D. SANsurfer
E. HBAnywhere
Answer: E
|
Question: 7
|
.
Which utility on Solaris 10 can be used to collect
information about firmware and driver versions for an Emulex LP1xxxx/LPe1xxxx
HBA?
A. EMutil
B. SANutil
C. hbainfo
D. SANsurfer
E. HBAnywhere
Answer: E
|
Question: 8
|
.
Which utility on Solaris 10 can be used to collect
information about firmware and driver versions for a Qlogic QLAxxx/QLExxxx HBA?
A. EMutil
B. SANutil
C. cfgadmin
D. SANsurfer
E. HBAnywhere
Answer: D
|
Question: 9
|
.
An organization currently has a NetApp Fibre Channel
block-based solution. With limited budget and resources, they want to create a
new disaster recovery site that utilizes a NetApp solution.
What would the optimal solution include?
A. SnapMover and Fibre Channel at the disaster recovery
site for all hosts
B. SnapMirror and iSCSI at the disaster recovery site for
all hosts
C. Fibre Channel at both locations using ftp to replicate
storage
D. MetroCluster and NAS
Answer: B
|
Question: 10
|
.
A company has a Fibre Channel environment and wants to
connect a new host in a remote data center using 50/125um OM2 multi-mode fiber
cable and needs to support 2 Gb speeds.
What is the maximum distance of the cable run supported
in this situation?
A. 50/125um OM2 multi-mode fiber cable supports up to 500
meters at 2 Gb.
B. 50/125um OM2 multi-mode fiber cable supports up to
10000 meters at 2 Gb.
C. 50/125um OM2 multi-mode fiber cable supports up to 150
meters at 2 Gb.
D. 50/125um OM2 multi-mode fiber cable supports up to 300
meters at 2 Gb.
Answer: D
|
Question: 11
|
.
Click the Exhibit button.
<exhibit name=NS0-502-11>
</exhibit>
Given the information provided in the diagram, what is
the appropriate FC topology?
A. point-to-point
B. switched fabric
C. arbitrated loop
D. ring
Answer: B
|
No comments:
Post a Comment